Bag-on-valve Aerosol Filling Line

Aerosol Filling Line

Bag-on-valve Aerosol Filling Line have two parts: The front parts of filling line is consist of Can Feeding Table,  3 heads propellant filling and crimping machine, 2 sets of booster pumps and stainless steel conveyors. The end parts of filling line is consist of Aerosol Check weigher,Water-bath Leakage Tester,Automatic Cap Presser

  • Up to 100% product emptying

  • Longer shelf life with less preservatives

  • Even and controlled spraying pattern for optimal result

  • No pumping motion needed

  • Can be used at all angles

  • Reduced spray noise

  • Less-chilling product discharge

Automatic bag on valve aerosol filling machine is force compressed air into the can, sealed with a bag on valve. Then filling raw materials into the bag. Make sure the raw materials and can body are completely isolated. Propellants by compressed air (purified) replaces the LPG liquefied gas, DME etc, solving the hassle from leakage caused by original materials corrosion the cans.

Open the valve when using, the inner compressed air pressure bag and extrusion the raw material out of cans. After the raw materials out completely, the inner compressed air is still there, it can repeat filling.


  • Pharma & Medical Devices

  • Health.

  • Fire control industry.

  • Daily Chemical Industry.

  • Cosmetics.

  • Food & Nutrition.

  • Miscellaneous.

Technical Parameters:

Outline (L*W*H) (mm)1500*6000*1800
Capacity (cans/hr)800-1800
Gas fill (ml)≤300 (Customizable)
Repeated filling accuracy0.5%
Diameter of cans (mm)35-65 (customizable)
Height of aerosol can (mm)30-400 (customizable)
Valve (mm)25.4 (1 inch)
Gas supply (MPA)0.5-0.7
Max. gas consumption (m^3/min)10

Request Consultation

Prev:Sorry,the content you searched does not exist.

Phone:+86 158 8872 1491


Yangzhou225105,Jiangsu Province,China

Request Consultation